Onkyo HT-R960 Service Manual page 101

DEBUG MODE-7
HDMI TROUBLESHOOT-1/3
HDMI VIDEO SETUP TROUBLE
This trouble shooting map focuses on the video setup errors regarding HDMI.
For reference, read TX-SR606 Owner's Manual.
Analysis written below is of typical cases. So, more detailed check may need in actual cases.
"Resolution Picture is OK
Error" is if player is
Display HDMI
displayed connected
DEBUG MODE
on FL directly to TV
Resolution or
Check aspect of TV
and player is
Information
different from
on FL
each other
Change Change player's Change
settings of TV, resolution or TX-SR606's
player or
aspect to TV's HDMI resolution
TX-SR606 capability to Through(1)
<Notes>
(1) Refer to Setup Menu 7-5. HDMI Setting
Resolution : Through.
(2) Refer to Setup Menu 7-5. HDMI Setting
x.v.Color : Disable.
No picture
No picture
"No HDCP
when HDCP-
support" is
capable DVD
displayed
or BD disc is
on FL
played
Player is not
EDID error HDCP-capable
TV is not
between TV or has special
HDCP-capable
and player HDCP authentic
procedure
Change player
Use Component
or consult with
Video instead
the player
of HDMI
maker
Example:
Use Component
Samsung
Video instead
DVD-HR737
Video trouble
Push
"No signal" is
DISPLAY
HDMI cable is
displayed
button for
NG or too long
on FL
3 sec.
Change to
Displays
short HDMI
"Unknown" Player is PC
on FL cable
Change
The resolution
Authentic No signal from resolution setting
is not
error player supported by of player to
1080i or less
HDMI
Check player's Change Change
setting and PC setting to TX-SR606's
HDMI cable HDMI supported HDMI resolution
of HDMI
connection resolution to Through(1)
Bad picture
Only 1080p is
Picture is dark Bad aspect
not displayed
Re-calibrate Set manually
video the aspect
TV does not
support 1080p processor IC setting of
in TX-SR606 player
TX-SR606
Picture is not
Bad color
right
Confirm and
Set TX-SR606's
change
x.v.Color setting
the TV setup
to disable (2) to match
the player
Confirm and
change
the player
setup to
match the TV