Controlling And Monitoring A Call - Cisco TelePresence System Quick Set C20 Administrator's Manual

Cisco TelePresence System Quick Set C20 and Profiles using C20
Contents Introduction

Controlling and monitoring a call

You can control and monitor several call features using the
Call Control page.
Adjusting the sound volume
Use + and - on the volume control bar to adjust the sound
volume of your system (not the keyboard
Muting the microphone
Use the Mute button when you want to deactivate the
microphone for privacy reasons.
When the microphone is muted, the button is replaced by an
Unmute button. Use this button to re-activate the microphone.
Controlling the camera
First, press the Camera Control button. Then, in the window
that opens, use + and - to adjust the zoom and the arrow keys
to adjust the camera's angle.
If a camera preset is defined it is listed to the right. Apply the
preset by clicking its name.
Call settings
When you load the Call Control page, the default call bit rate
and the default call protocol are shown in the
Call protocol fields, respectively. If preferred, you can select
another bit rate or another protocol from the drop down lists.
You can not change these settings during a call.
Call details
Press Show details while in a call to provide information on
call rate, encryption, as well as important video and audio
parameters.
Hide details removes the information.
D14637.08 Profile C20 and Quick Set C20 Administrator Guide TC5.1, February 2012.
Copyright © 2010-2012 Cisco Systems, Inc. All rights reserved.
Web interface
+ and - keys).
Call bit rate and
Show/hide
call details
Call bit rate
Call protocol
Call Control
Advanced settings Password protection
20
Administrator guide
Appendices Contact us
Volume control
Microphone mute
Camera control
www.cisco.com