Changing The Main Fuse - KTM 450 SX-F EU Owner's Manual

14 ELECTRICAL SYSTEM
14.4

Changing the main fuse

Warning
Fire hazard The electrical system can be overloaded if the wrong fuses are used.
–
Use only fuses with the prescribed amperage. Never by-pass or repair fuses.
Info
The main fuse protects all power consumers of the vehicle. It is located in the starter relay housing under the air filter box lid.
Preparatory work
–
Switch off all power consumers and switch off the engine.
–
Remove the air filter box lid. (
Main work
–
Remove screw
C00240-10
–
Lift rear fairing
S00046-10
–
Remove protection caps
–
Remove the faulty main fuse
Info
A defective fuse can be identified by the burned-out fuse wire
A reserve fuse
–
Install a new main fuse.
Fuse (58011109110) (
101089-10
–
Check that the electrical equipment is functioning properly.
Tip
Insert the spare fuse so that it is available if needed.
–
Mount the protection caps.
–
Mount the starter relay onto the holder and lay the cable.
–
Position the rear fairing. Mount and tighten the screw.
Guideline
Remaining screws, chassis
Finishing work
–
Install the air filter box lid. (
p. 45)
.
1
slightly and pull starter relay
2
.
4
.
5
is located in the starter relay.
6
p. 92)
p. 45)
out of the holder.
3
A
M6 10 Nm (7.4 lbf ft)
73
.