US Robotics Wireless 54Mbps ADSL Router User Manual page 70

T
ROUBLESHOOTING
Note: Ad hoc mode is used for peer-to-peer network configurations.
Infrastructure mode is used for integrated wireless and wired LAN
configuration.
My computer does not recognise the wireless function of the Wire-
less 54Mbps DSL Router after I changed the settings.
Possible Solution:
Ensure that you are connecting to the correct Wireless 54Mbps DSL
Router by verifying the correct MAC address. Ensure that the correct
passphrase and encryption option is being used. If you changed the
settings in the configuration of the Wireless 54Mbps DSL Router, you
must also change the settings of every Wireless adapter attached to
this network. The settings of the Wireless adapters must match the
new settings of the Wireless 54Mbps DSL Router.
I cannot achieve 54 Mbps connections to the Wireless 54Mbps DSL
Router.
Possible Solution:
Make sure the wireless products you are using to connect to the
Wireless 54Mbps DSL Router support 54 Mbps speeds. 54 Mbps
wireless products must be used in order to connect to the Wireless
54Mbps DSL Router at a rate of 54 Mbps. Launch the router's Web
User Interface and manually set the connection speed to 54 Mbps. If
you are using non-U.S. Robotics wireless products, you may need to
upgrade the firmware for those products in order to support 54 Mbps
connections.
Possible Solution:
Low connection speed or range can also be caused by environmental
interference. Try to move the product around to improve the link
quality. In addition, keep in mind that other factors such as lead
68