Installation And Shaft Seal Replacement 700 & 1000; Upper Nut And Bearing Assembly; To Replace Bearing - Cornelius 500 Series Installation And Service Manual

I
NSTALLATION AND
1. Place the shaft seal locator seat and shaft seal mount over the gear motor output shaft and push down until the
shaft seal seat and shaft seal mount rest flush on top of the gear motor.
2. Place the rubber coated ceramic seal (important: ceramic face up) over the output shaft and push down until
the seal rests in the recess of the shaft seal mount. (lubricate the rubber on the ceramic seal with rubber lubri-
cant).
3. Place the shaft seal with the carbon face down (spring up) over the output shaft and push (gently) downward
until the seal rests on the carbon face of the output shaft seal.
4. Place flat washer over the output shaft and let it rest on the output shaft seal. Push down on the washer, com-
pressing the spring on the output shaft seal. While holding the seals (down) in place slide the E-ring into the
groove on the output shaft.
U N
PPER UT AND
The upper white bearing located on top of the auger is used to absorb the force between the auger and extruding
head.
NOTE: The bearings are 3/32" thick. When they wear below 1/16" they should be replaced.
Bearings to be inspected for wear during quarterly maintenance. (See Figure 12)

To Replace Bearing

!
WARNING:
Disconnect power to the unit before servicing. Follow all lock out/tag out procedures established by the user. Verify all
power is off to the unit before performing any work.
Failure to comply could result in serious injury, death or damage to the equipment.
1. Remove top panels.
2. Remove Dispense Tray cover.
3. Use an open end wrench on the auger nut connected to the bearing and turn counterclockwise to remove the
assembly.
4. Remove worn bearings. Replace them with new bearings and then reinstall assembly.
© 2002-2014, Cornelius Inc.
Figure 19. Shaft Seal 700 and 1000
S S R
HAFT EAL EPLACEMENT
B A
EARING SSEMBLY
Continuous Flow Icemaker Installation and Service Manual
700 & 1000
- 22 -
(See Figure 20)
Publication Number: 638085278