Motor Check; Installation And Shaft Seal Replacement - Cornelius CMP 600-30 Service Manual

CMP600-30 Icemaker Dispenser Service Manual
M C :
OTOR HECK
The resistance readings on the windings will be between 5 to 25 ohms. A meter capable of these low readings must
be used. The Start Relay cover must be removed. NOTE: Gear motor and related components can be checked from
Pin Connector. See Figure 5 and Figure 6.
If no continuity on start or run winding test, replace stator. If continuity on grounded motor test, replace stator.
I
NSTALLATION AND
1. Place shaft seal locator seat over gear motor output shaft, embossed side down, and push down until shaft
seal seat rests flush on top of gear motor.
2. Place rubber coated ceramic seal (important: ceramic face up) over output shaft and push down until seal rests
on top of the shaft seal seat. (Lubricate rubber on ceramic seal with [#06195] rubber lubricant.)
3. Place shaft seal with carbon face down (spring up) over output shaft and push (gently) downward until seal
rests on carbon face of the output shaft seal.
4. Push down on the washer compressing the spring on the output shaft seal. While holding the seals (down) in
place slide the E–ring into the groove on the output shaft.
A & E
UGER XTRUDING
Figure 6. Shaft Seal Replacement
Publication Number: 630460050SER
S S R
HAFT EAL EPLACEMENT
H R
EAD EMOVAL
Figure 7. Extruding Head
(See Figure 6)
- 14 -
Figure 8. Auger
© 2004-2014, Cornelius Inc.