e_ka250.book Page 13 Tuesday, September 5, 2006 4:10 PM
Operation
1.
Turn the RM-P210 on.
Turn the [POWER] switch of the camera remote control
unit to [ON]. CALL button lights up green when the power
is turned on. After the [POWER] switch is turned on, cam-
era remote control unit can be operated after about 30
seconds.
MEMO
After the power is turned on, the camera remote control unit
takes about 30 seconds to be ready to communicate with
this unit.
2.
Press the [CALL] button.
Press and hold down the [CALL] to send call signals to
the remote control unit operator. The [TALLY] button indi-
cator of the remote control unit blinks.
[CALL] button indicator changes from green to red while
the button is pressed. The [TALLY] lamp on the view-
finder also blinks when call signals are received from the
remote control unit.
3.
Adjust the volume.
Adjust the headset reception volume with [INCOM
LEVEL].
CALL
button
INCOM LEVEL
volume
MEMO
• If both this unit (including the camera) and the remote
control unit have the same functional switches, the
remote control unit switches are prioritized.
• If local Remote Control Unit (RM-LP55 or RM-LP57) is
used simultaneously, the local remote control unit is pri-
oritized.
• If external synchronization signal is present when the
power is turned on, pictures may appear choppy for a
few seconds. This is not a malfunction.
• When using the remote control unit, refer to its instruc-
tion manual for details.
13