Turning The Chime On/Off; Testing The System; Bell Test - Scantronic 9800+ User Manual

4. Special Functions
Table 1 (Cont'd) . Log Event Codes
Code Meaning
Lt Control unit lid tamper
†
o1 to o16 Zone omitted
P1 to P4 Remote keypad dual key PA alarm
PF Mains power failure
PL Print log.
r1 to r4 Remote keypad enclosure tamper
rP Remote keypad missing
rr Installer reset
rt Remote keypad excess key presses
†
S1 to S16 Zone soak Test
Sr System reset
St Set time
†
t1 to t16 Zone tamper violation
tr Tamper return fault
u1 to u8 Access user (u9 = Duress, u0 = keys
†
When showing zones 10 to 16 the display alternates between the letter 'c'
and the number of the zone.

Turning the Chime On/Off

Your system may be programmed so that a chime tone sounds whenever
certain doors are opened while the system is unset. If your system has an
Exit Terminate button, then it will act as a door bell while Chime is on. To turn
Chime on or off:
1. Key in your access code.
The display shows "_ _ "
2. Press 7 followed by

Testing the System

Bell Test

You can test that the internal and external sounders, and the strobe, are all
working as follows:
1. Key in your access code.
The display shows "_ _ "
2. Press 8.
The system turns the external sounder, strobe, internal sounder(s) and
keypad sounders on for three seconds each, one after the other.
3. Press (Clear) to finish the test.
16
(Clear).
496247 Issue 4
tamper
witch)