Special Functions; Introduction; Omitting Zones - Scantronic 9800+ User Manual

4. Special Functions

Introduction

You can perform a number of other functions, apart from setting and unset­
ting the system. These functions are:
[Access code] + X
[Access code] + 3
[Access code] + 4
[Access code] + 5
[Access code] + 7
[Access code] + 8
[Access code] + 9
To use these functions you must key in your access code and then press a
number key. The rest of this section describes each function in turn.

Omitting Zones

Your system may be programmed so that you can omit individual detectors
when setting the system. Ask your Installer which zones can be omitted. Note
that omission is not permanent. You must omit the zone every time you set
the system.
To set with a zone omitted:
1. Key in your access code.
2. Press the appropriate Level key, and then within 5 seconds:
3. For zones 1 to 9 press X (Omit) followed by the number(s) of the
zone(s) you want to omit (for example, key in X(Omit) 2 to omit zone 2).
For zones 10 to 16 press X (Omit) twice followed by a number 0 to 6
(for example, key in X (Omit) X (Omit) 2 to omit zone 12).
The display shows the zone number of the detector that will be omitted.
The system carries on to set as normal. The system will not raise an
alarm if the omitted zone is triggered. Note that the next time you set the
system the zone will operate as normal; omission only lasts for one
setting/unsetting cycle.
12
Setting the system so that some zones are by­
passed or omitted.
Setting the time and date on the system's internal
clock.
Changing access codes.
Reading the system log.
Turning the chime function on or off.
Testing the sounders.
Testing the zones.
496247 Issue 4