Omitting 24 Hour Zones; Setting The Time And Date - Scantronic 9800+ User Manual

Omitting 24 Hour Zones

If your system is fitted with 24 hour detector zones, you may be able to omit
them if necessary. For example, your premises may have a fire door that you
occasionally open. Ask your Installer if this is possible.
If your system is programmed to allow you to omit a 24 hour zone, then:
1. Key in your access code.
2. For zones 1 to 9 press X (Omit) followed by the number(s) of the
zone(s) you want to omit (for example, key in X(Omit) 7 to omit zone 7).
For zones 10 to 16 press X (Omit) twice followed by a number 0 to 6
(for example, key in X (Omit) X (Omit) 2 to omit zone 12).
To reinstate a 24 hour zone:
1. Key in your access code.
2. Press X (Omit) followed by

Setting the Time and Date

The control unit contains an internal clock/calendar that runs as long as there
is power present (mains or stand-by battery). The system uses this clock to
mark the time and date on the system log. If the power supply fails for any
reason, and the stand-by battery is low, then the system loses track of the
correct time and date. You may also need to change the time if you live in an
area that uses summer/winter time.
Note: You need the access code for User 1 in order to change the time and date.
To set the time and date:
1. Key in User 1 access code.
2. Press 3.
The display shows "yy" for the year.
3. Key in two digits for the year followed by
The display shows "oo" for the month.
4. Key two digits for the month (01 for January, to 12 for December)
followed by (Clear).
The display shows "dd" for the day
5. Key in two digits for the day, followed by
The display shows "hh" for the hour
6. Key in two digits for the hour followed by
clock.)
The display shows "ii" for the minutes.
(Clear).
(Clear).
(Clear).
(Clear). (Use the 24 hour
496247 Issue 4
4. Special Functions
13