Table of Contents
Advertisement
3.
Return to the keypad and set the system again.
If no other detectors are active the system sets.
4.
Repeat steps 1 to 3 if the display shows other zones.
5.
If you still cannot set the system then call the engineer.
Unsetting the System
Unsetting From a Keyswitch
Turn the keyswitch to OFF. The system unsets immediately.
Unsetting From the Keypad
The system has a programmed entry time. Ask your Installer to make sure
the entry time is long enough for you to enter by the designated entry route,
get to the keypad and unset the system.
The entry time starts when you open the designated entry door. During the
entry time the keypads give a "galloping" entry tone to warn you that the
timer is running.
1.
Enter through the designated entry door and go to the keypad.
As you enter the premises the system starts the entry timer and the
keypad gives the entry tone.
2.
Key in your access code at the keypad.
The entry tone stops. The system is now unset.
If You Exceed the Entry Time
If you regularly have problems exceeding the entry time, ask your installer
about "Dual Ply Entry" and "Alarm Abort".
If the system is programmed for Dual Ply Entry, then the control unit adds a
30 second grace period to the end of the Entry Time. During that grace
period the keypads give a high pitched continuous tone to warn you that the
Entry Time has run out.
When programmed for Alarm Abort the system gives you 90 seconds after
the end of the Entry Time to cancel any alarm caused by exceeding the Entry
Time or leaving the entry route. If you exceed the 90 second Alarm Abort
time then the panel gives a full alarm, and you may have to call an engineer
to reset your system.
496247 Issue 4
2. Everyday Operation
9
Hide quick links:
Advertisement
Table of Contents
