Table of Contents
Advertisement
4.
Leave via the designated exit route. Close the final door.
At the end of the exit time the system sets, and stops the exit tone. The
Level LED glows steadily to show which Level is set.
Note: If you change your mind about setting the system either press
five seconds of entering your code, or key in your access code again if you
miss the first five seconds.
Exceeding the Exit Time
If you do not close the final door before the end of the exit time then the
system gives an alarm and does not set. You can cancel this false alarm by
entering your access code at the keypad immediately.
When you have cancelled the alarm you will have to reset the system and
restart the setting procedure.
Final Door Set
With Final Door setting the system sets when you close the last door. There
is no fixed exit time.
1.
Close all doors and windows.
2.
Key in your access code at the keypad.
3.
Press the appropriate Level key.
The keypad starts the continuous exit tone and the Level LED flashes.
4.
Leave via the designated exit route and close the final door.
Exit Terminate Button Set
In Exit Terminate Button setting the system completes setting after you press
a button mounted outside the premises by the final door.
1.
Close all doors and windows.
2.
Key in your access code at the keypad.
3.
Press the appropriate Level key.
The keypad starts the continuous exit tone and the Level LED flashes.
4.
Leave via the designated exit route. Close the final door.
5.
Press the exit terminate button.
The exit tone stops and the system sets. The Level LED glows steadily.
Note: The Installer may have programmed your system to set after a fixed time even
if you do not press the exit terminate button. This is to make sure your
premises are protected even if you forget to press the exit terminate button.
Ask your Installer how your system is set up.
496247 Issue 4
2. Everyday Operation
(Clear) within
7
Hide quick links:
Advertisement
Table of Contents
