Scantronic 9449 User Manual
  1. Manuals
  2. Brands
  3. Scantronic Manuals
  4. Control Panel
  5. 9449
  6. User manual
Scantronic 9449 User Manual

Scantronic 9449 User Manual

Hide thumbs
Table of Contents

Advertisement

Quick Links

Download this manual
Scantronic
Leading the way in security

Advertisement

Table of Contents
loading

Related Manuals for Scantronic 9449

Summary of Contents for Scantronic 9449

  • Page 1 Scantronic Leading the way in security...

  • Page 2: Zone

    TO FULL SET Key-in your four digit user code (shown as ???? at left). The exit tone starts. Leave premises via the designated exit door. Exit tone stops after preset time (or within seven seconds of pressing the exit terminate button). Your alarm system is SET. TO PART SET Your alarm system may have been installed to allow you to have part of the premises set while other...

  • Page 3: After An Alarm

    AFTER AN ALARM Fire Alarm: The system gives a fire alarm by sounding a warbling tone from the internal sounder. 1. Evacuate the premises and call the Fire Brigade. Do not attempt to unset the alarm. 2. When the premises are safe, follow the instruc­ tions below.
  • Page 4 The central station will give you a new four digit Anti - code code, the “anti-code”, note it down. 5. Enter the code given by the central station. The Service light goes out. 6. Key in your user code. The system is now ready for use.

  • Page 5: Telephone Line Failure

    TO OMIT A DETECTOR You may need to temporarily set the system with Repeat for each zone one or more detectors omitted. Key in the zone number followed by OMIT for all the zones you want Zone to omit and then key in your user code. The system flashes the light(s) of the omitted zone(s) during the OMIT exit time and then sets.

  • Page 6: Setting The Internal Clock

    SETTING THE INTERNAL CLOCK The system has an internal clock. If you have a log ENTER printer, the log shows events occurring at the correct time. (The Installer may have already set the clock for you.) If you need to change the time and date: Make sure the system is unset.
  • Page 7 sounder Flashing Power Power Power Power Fault Fault Fault Fault Service Service Service Service "dee - dah" Tamper Tamper Tamper Tamper Alarm (zone 1). Alarm (zone 1). Call 24Hr, Technical or PA Fire (zone 7). Leave Customer reset engineer. zone active. Reset PA premises until you are required.
  • Page 8 Every effort has been made to ensure that the contents of this book are correct, errors and omissions excepted. However, neither the authors nor Scantronic accept any liability for loss or damage caused or alleged to be caused directly or indirectly by this book. The contents of this book are subject to change without notice.

Table of Contents