Table of Contents
Advertisement
7.
Press Enter.
The displays shows:
The system carries on to set as normal. The system will not raise an
alarm if the omitted zone is triggered. Note that the next time you set the
Level the system will treat the zone as normal; omission only lasts for
one setting/unsetting cycle.
Omitting 24 Hour Zones (Menu 2)
If your system is fitted with 24 hour detector zones, you may be able to omit
them if necessary. For example, your premises may have a fire door that you
occasionally open. Ask your Installer if this is possible.
If your system is programmed to allow you to omit a 24 hour zone, then:
1.
Key in your access code.
2.
Press Menu followed by 2.
The display shows:
3.
Press Enter.
The displays shows (for example):
4.
Press A or B until the display shows the 24 hour
zone that you want to omit. Note that some zones
may not be programmed for omission.
5.
Press C or D until the display shows the words "OMIT YES".
6.
Press Enter.
The displays shows:
The system will not raise an alarm if the omitted zone is triggered.
To reinstate a 24 hour zone: repeat steps 1 to 6 but at step 5 press C or D to
make sure the display shows "UN-OMIT".
Turning the Chime On/Off (Menu 3)
Your system may be programmed so that a chime tone sounds whenever
certain doors are opened. If you want to turn this feature on or off:
1.
Key in your access code and press Menu followed by 3.
The display shows:
2.
Press Enter.
The system displays the current state of the
chime function:
496235 Issue 1
4. Special Functions
READY LEAVE
2-OMIT 24 HR ZO
FIRE DR
OMIT NO
2-OMIT 24 HR ZO
3-SYSTEM OPTNS.
CHIME D
13
Advertisement
Table of Contents
