Using The Log - Scantronic 9800+ User Manual

3. Key in the access code you wish to change.
The display shows "nc" (new code).
4. Key in the new access code that you wish to use.
Note: Do not use 0 (zero) as the first digit of the code.
5. Press (Clear) to store the new code.

Using the Log

The system keeps a log of the last 256 events. You can examine this log
from the keypad. To use the log:
1. Key in your access code.
2. Press 5.
The display shows the user number belonging to the access code you
used.
3. Press 1 to see earlier events in the log. Press 3 to see more recent
events.
The display shows a two character code for each type of event. Table 1
on the next page shows each of the codes that you might see, and their
meaning.
4. Press (Clear) twice to stop using the log.
Table 1. Log Event Codes
Code Meaning
AA Arm area A (full set)
Ab Arm area B (part set)
Ac Arm area C (part set)
AE Installer access
AP Auxiliary power failure
bF Battery fault
c1 to c16 † Zone violation
cc Communication successful
cF Communications failure
dA Disarm area A
db Disarm area B
dc Disarm area C
†
E1 to E16 Entry via zone circuit
EA Entry alarm
EF Exit fault
Lb Low battery
Lf Telephone line failure
496247 Issue 4
4. Special Functions
P.T.O.
15