To Read The Log; To Change Your User Code - Scantronic 9448+ User Manual

TO READ THE LOG

8
The system keeps a log of the last ten alarm or tamper
events. To read the log key in 8 then
user code. The system switches on the zone or Tamper
? ? ? ?
lights to show you the most recent event. If you want to
see earlier events then press ‘<<‘ (the 1 key). To see
Keypad shows most recent
more recent events press ‘>>’ (the 3 key). The keypad
event.
gives a short tone when you reach either end of the log.
<<
To leave the log press OMIT or
Earlier events.
>>
Later events.

TO CHANGE YOUR USER CODE

Your system provides two separate four digit user codes.
6
When the system is new, the user codes are “1234” and
“0000”. Change the “1234” user code immediately to a
number that only you know. The new code can be any
Your Existing Code No.
four digit code you choose EXCEPT “0000”.
Followed by:
The “0000” user code is inactive and will not operate the
system. To activate the second user code change the
The Code to be Changed.
“0000” to another four digit number. To inactivate the
Two Bleeps from
second user code again, change it back to “0000”.
Sounder
DO NOT use the same number for both user codes.
The New Four Digit Code
Two Bleeps from
Sounder
Note: The control unit does not use the
keypad. Also, ignore the
no function on your system.
Zone Descriptions
Entry Exit Zone:
Zone 1:
Zone 2:
Zone 3:
Zone 4:
Zone 5:
Zone 6:
Installer Name:
Day Tel:
Night Tel:
Part No. 496237 Issue 4
R
followed by your
R
.
D
light on the
t
symbol over the 9 key, it has
USER GUIDE
HARDWIRED CONTROL
PANEL
Scantronic
Leading the way in security