Operation; Cutting Capacity - Makita 2414NB Instruction Manual

003764
When cutting workpieces over 65 mm wide at an angle,
attach a straight piece of wood (spacer) over 190 mm
long x 45 mm wide to the guide plate as shown in the
figure. Attach this spacer with screws through the holes
in the guide plate.
1
2
5
3
4
005342
If you use a spacer block which is slightly narrower than
the workpiece as shown in the figure, you can also utilize
the wheel economically.
1
5
4
003766
Long workpieces must be supported by blocks of
non-flammable material on either side so that it will be
level with the base top.
003767
1. Spacer block
1
1. Guide plate
2. Straight piece of
wood (Spacer)
3. Over 45 mm
long
4. Over 65 mm
long
5. Over 190 mm
long
1. Diameter of
2
workpiece
2. Guide plate
3
3. Spacer block
4. Width of spacer
block
5. Vise
1. Blocks
1

OPERATION

Hold the handle firmly. Switch on the tool and wait until
the wheel attains full speed before lowering gently into the
cut. When the wheel contacts the workpiece, gradually
bear down on the handle to perform the cut. When the cut
is completed, switch off the tool and WAIT UNTIL THE
WHEEL HAS COME TO A COMPLETE STOP before
returning the handle to the fully elevated position.
CAUTION:
Proper handle pressure during cutting and
•
maximum cutting efficiency can be determined by
the amount of sparks that is produced while cutting.
Your pressure on the handle should be adjusted to
produce the maximum amount of sparks. Do not
force the cut by applying excessive pressure on
the handle. Reduced cutting efficiency, premature
wheel wear, as well as, possible damage to the
tool, cut-off wheel or workpiece may result.

Cutting capacity

Max. cutting capacity varies depending upon the cutting
angle and workpiece shape. Applicable wheel diameter:
355 mm
Workpiece
shape
Cutting
angle
90°
45°
Workpiece
shape
Cutting
angle
115mm x 130mm
90° 102 mm × 194 mm
70 mm × 233 mm
45° 115mm x 103mm
005270
7
115 mm 119 mm
115 mm 106 mm
137 mm
100 mm