Memory Scan - Yaesu FT dx 1200 Operating Manual

1. Set the transceiver up in the "Memory" mode by
pressing the [ V/M ] button, if necessary.
2. Rotate the [ RF/SQL ] knob so that the background
noise is just silenced.
3. Press and hold in the microphone [ UP ] or [ DWN ]
key for one second to start scanning in the specified
direction.
A :
dvice
 If the scanner halts on an incoming signal, the
decimal point between the "MHz" and "kHz"
digits of the frequency display will blink.
 If the incoming signal disappears, scanning will
resume in about five seconds.
4. To cancel scanning, press the [ PTT ] witch.
A :
dvice
 During Memory Group operation, only the channels
within the current Memory Group will be scanned.
 If the scan has paused on a signal, pressing the mi-
crophone [ UP ] or [ DWN ] key will cause scanning to
resume instantly.
 If you press the microphone PTT switch during
scanning, the scanner will halt at once. However,
pressing the PTT switch during scanning will not
cause transmission.
 You may select the manner in which the scanner re-
sumes while it has paused on a signal, using Menu
item "048 MIC SCAN RESUME". During memory
scanning, the default "TIME" (5 sec) setting will
cause the scanner to resume scanning after five
seconds. However, you may change this setting to
resume only after the carrier has dropped out, if you
like.
q p :
uick oint
If you have no interest in scanning, and wish to prohibit
the microphone [ UP ] / [ DWN ] keys from initiating scan-
ning, you may disable scanning control from the mi-
crophone using Menu item "047 MIC SCAN" (set it to
"DISABLE").
FT 1200 O
DX peraTing
vfo
anD
M
eMory
M
anual
m
emorY
S
cAn
[ RF/SQL ] Knob
s
canninG
[ V/M ] Button
Page 101