Yaesu FT1DR Instruction Manual page 62

Tip
• If you are to connect the transceiver with a PC using SCU-18, the following settings must be applied
on the PC.
DATA SPEED: 9600bps (the SPEED setting of this transceiver and a PC must correspond).
DATA LENGTH: 8bit
Parity Bit:
Stop Bit:
O 18 DIGI PATH
Setting the digipeater route.
Setting item: P1
Default: P3 FWIDE1-1 AWIDE2-1 (fixed value)
Explanation:
A station that relays packets, such as beacons, are called a digipeater.
Select a CALLSIGN or ALIAS of the digipeater you would like to use.
In this transceiver, [WIDE1-1/WIDE2-1] (setting for 2 relay stations) is set beforehand.
In [WIDE1-1, WIDE2-1], a transmission is relayed to the first digipeater station specified
as WIDE1-1, then to the second digipeater station specified as WIDE2-1.
As of January 2013, digipeater stations used by APRS are recommended to be
operated using *New- Paradigm.
The initial values set to this transceiver are those premised for digipeater stations
operating with New- Paradigm, due to most digipeater stations supporting this method.
In order to use other relay methods, select one of P4 to P8 and enter the CALLSIGN or
ALIAS.
* For information on the New-Paradigm method, refer to the following websites for
details.
http://aprs.org/fix14439.html
O 19 GPS DATUM
Select DATUM
Setting Item: WGS-84 / Tokyo Mean / Tokyo Japan / Tokyo Korea / Tokyo Okinawa
Default: WGS-84
Explanation: Because APRS uses the DATUM of WGS-88, this setting is not changed
61
None
1bit
OFF
P2: WIDE1-1 (fixed value)
P3: WIDE1-1, WIDE2-1 (fixed value)
P4 to P7: Up to 2 addresses can be entered arbitrarily.
P8: Up to 8 addresses can be entered arbitrarily.
under normal circumstances.
APRS Set mode function list