Yaesu FT1DR Instruction Manual page 44

Press H.
7
The cursor moves to the 1
8
Enter the characters using keypad keys.
Press H.
9
The cursor moves to the next character position.
When F is pressed, a character is deleted and the cursor
Tip
moves to left.
10
Repeat steps 8 and 9 to enter characters.
Up to 16 characters can be entered.
Press p.
11
Registers the fixed text and exits from the Set mode.
Tip
When entering characters, press 0 to enter [0], [SPACE], [-], [%], [/], [?], [!], [.], [:], or [#].
O Message reception verification data (ACK)
When transmitting messages to another station, ACK (message reception verification data)
indicating the message was received is automatically sent back in response.
When ACK data is received from the other station, a reception confirmation alarm sounds,
and the transmission process is completed.
If ACK data is not sent from the other station after 1 minute, the same message is
retransmitted to the other station.
If ACK data is not sent from the other station after 5 attempts, the message is displayed
to be TX OUT. The remaining transmission attempts of ACK appear on the LCD as shown
below.
The remaining number of attempts can also be checked by pressing H and switching to
the transmission details screen.
43
st
character position.
List Table of Enterable Characters to Messages
Transmitting an APRS
®
Message