Yaesu FT1DR Instruction Manual page 58

O 13 BEACON INFO
Setting the transmit beacon information
Setting item: AMBIGUITY: OFF / 1digi / 2digi / 3digi / 4digi
Default: AMBIGUITY: OFF
SPD/CSE:
ALTITUDE:
Explanation:
AMBIGUITY:
SPD/CSE:
(SPEED/COURSE)
ALTITUDE:
O 14 BEACON INTERVAL
Automatic transmission interval settings for beacon
Setting item: 30sec / 1min / 2min / 3min / 5min / 10min / 15min / 20min / 30min / 60min
Default: 5 minutes
Explanation:
Set the automatic transmission interval for transmission of APRS beacons.
• Set the Set mode option [9 APRS]
transmission is reset when the automatic transmission interval is set.
From this point, the count for interval time begins, and the initial beacon is
automatically transmitted when the specified time is reached.
• If squelch is active when the interval for automatic beacon transmission is reached,
the transmission is stopped.
The beacon is transmitted when squelch is deactivated.
• If SMART is selected in [9 APRS]
INTERVAL is ignored.
57
SPD/CSE: ON / OFF
ALTITUDE: ON / OFF
ON
ON
This function is for masking lower denominations of your position
(longitude, latitude) to disambiguate the position of your station.
Setting this function to [OFF] disables disambiguation and
transmits the precise position information of your station.
OFF
35°38.17'
139°42.33'
If function is set to [ON], speed and directional information is
transmitted. If this function is set to [OFF], speed and directional
information is not be transmitted.
If this function is set to [ON], altitude information is transmitted.
If this function is set to [OFF], altitude information is not
transmitted.
1digi 2digi
35°38.1… 35°38.……
139°42.3… 139°42.……
[16 BEACON TX] to [AUTO]. The timer for
[16 BEACON TX], the setting for BEACON
APRS Set mode function list
3digi
35°3 ….……
139°4 ….……
139°…….……
4digi
35°…….……