Advanced; Virtual Server - D-Link AC750 User Manual

Section 3 - Configuration
This will allow you to open a single port. If you would like to open a range of ports, refer to the next page.
Name: Enter a name for the rule or select an application from the
drop-down menu. Select an application and click << to
populate the fields.
IP Address: Enter the IP address of the computer on your local network
that you want to allow the incoming service to. If your
computer is receiving an IP address automatically from the
router (DHCP), you computer will be listed in the "Computer
Name" drop-down menu. Select your computer and click
<<.
Private Port/ Enter the port that you want to open next to Private Port
Public Port: and Public Port. The private and public ports are usually
the same. The public port is the port seen from the Internet
side, and the private port is the port being used by the
application on the computer within your local network.
Protocol Type: Select TCP, UDP, or Both.from the drop-down menu.
Schedule: The schedule of time when the Virtual Server Rule will be
enabled. The schedule may be set to Always, which will
allow the particular service to always be enabled. You can
create your own times in the Tools > Schedules section.
Select Allow.All (most common) or a created Inbound filter.
Inbound Filter:
You may create your own inbound filters in the Advanced.
>.Inbound.Filter page.
D-Link DIR-816L User Manual

Advanced

Virtual Server

117