D-Link AC750 User Manual page 107

Section 3 - Configuration
Static.IPv6.Address.Connection
This mode is used when your ISP provides you with a set IPv6 addresses that does not change. The IPv6 information is manually entered in your
IPv6 configuration settings. You must enter the IPv6 address, Subnet Prefix Length, Default Gateway, Primary DNS Server, and Secondary DNS
Server. Your ISP provides you with all this information.
Use Link-Local
The Link-local address is used by nodes and routers
Address:
when communicating with neighboring nodes on the
same link. This mode enables IPv6-capable devices to
communicate with each other on the LAN side.
IPv6 Address: Enter the WAN IPv6 address for the router here.
Subnet Prefix Enter the WAN subnet prefix length value used here.
Length:
Default Gateway: Enter the WAN default gateway IPv6 address used here.
Primary IPv6 DNS Enter the WAN primary DNS Server address used here.
Address:
Secondary IPv6 DNS Enter the WAN secondary DNS Server address used here.
Address:
LAN IPv6 Address: These are the settings of the LAN (Local Area Network)
IPv6 interface for the router. The router's LAN IPv6
Address configuration is based on the IPv6 Address and
Subnet assigned by your ISP. (A subnet with prefix /64 is
supported in LAN.)
D-Link DIR-816L User Manual 102