Assigning A Port Id To A Handset; Setting The Base Station Dip Switches For A Single-Base Station Application; Setting The Base Station Dip Switches For A Two-Base Station Application - Avaya 7406E Installation And Configuration Manual

42 Chapter 4 Registering, deregistering, and resetting the Avaya 7406E Digital Mobile Handset
Setting the base station DIP switches for a single-base station
application
Refer to Appendix A, "DIP switch settings," on page
1 Locate the base station DIP switches at the back of the base station.
2 Set the DIP switches to normal operating mode.
Setting the base station DIP switches for a two-base station
application
If you install two base stations, and there is interference between the two when in normal operating
most, you can set one base station to operate in the band A (upper band) and the other base station
to operate in band B (lower band). For the DIP switch settings for each operating mode, refer to
Appendix A, "DIP switch settings," on page
1 Locate the base station DIP switches at the back of the first base station.
2 Set the DIP switches to normal operating mode for a two-base station application—base
station A.
3 Locate the base station DIP switches at the back of the second base station.
4 Set the DIP switches to normal operating mode for a two-base station application—base
station B.
The base stations each now operate in one half of the ISM band.

Assigning a port ID to a handset

You cannot assign the same port ID to two handsets. If you assign a handset a port ID that is
already used by a second handset, the new handset registers with that port ID and that information
is discarded from the second handset.
A single handset can only have one port ID. If you assign a new port ID to a handset, the original
port ID and registration information clears from the handset. The handset loses its link to the base
station to which it was originally registered.
Before you register handsets, you must assign a unique port ID to each handset that you intend to
register with the base station.
1
When the phone is in standby mode, press the Func key.
The phone enters System Programming mode.
2 Use the up and down softkeys to navigate to the Maintenance menu.
3
Press Select.
You are prompted to enter a password.
4 Use the number keys to enter the maintenance password. To correct an error in the password,
press Delete to backspace.
NN40110-301 NN40110-301
53" for the correct settings for each mode.
53.