Handset Power - Avaya 7406E Installation And Configuration Manual

Place the handset in the charge cradle for charging when it is not in use.
A fully depleted battery is restored to full charge in three hours.
H
andset power
Power to the handset comes from the battery pack installed in the back of the handset. When the
battery pack power level is low it must be recharged in the charging cradle.
Low battery
When the power is low, a tone sounds every 15 seconds indicating you need to recharge the battery
soon. Your call is automatically put on hold 20 seconds after the battery pack runs out.
Recharging the battery
Recharging begins as soon as you put the handset in the charging cradle. Refer to
battery pack for the first time" (page
Be sure that the handset and charger contacts touch.
Note: If you do not correctly install the Avaya 7406E Digital Mobile Handset
battery, or if the battery level is extremely low, the six programmable buttons can
light or flash simultaneously. This can also happen when the handset is in the
charger.
Battery levels
The following icons appear on the display.
Indicates battery pack is fully charged.
Indicates battery pack is 2/3 charged.
Indicates battery pack is 1/3 charged.
Indicates battery pack is completely
discharged.
39).
Avaya 7406E Digital Mobile Handset Installation and Configuration Guide
Chapter 2 Introduction
"Charging the
33