Handset Overview; Monitoring Handset Signal Strength - Avaya 7406E Installation And Configuration Manual

20 Chapter 2 Introduction
Office with adjacent yard area(s)
95 m
(300 ft)
Unsuitable environments
Large campuses (business sites with more than one building) are not a suitable application for the
Avaya 7406E Digital Mobile Handset.
For this type of environment, contact your authorized Avaya distributor to discuss alternatives.

Handset overview

The Avaya 7406E Digital Mobile Handset handset automatically links with the base station by
searching for the base station signal after you complete following tasks:
• charge the battery
• power the base station and handset
• configure the handset identification

Monitoring handset signal strength

When you move too far from the base station, the following occurs on the handset:
• the Out of range... message appears
• the handset produces an intermittent beep
• the handset goes into scanning mode
Move back into range of the base station to stop the handset display messages and warning tones.
If you go out of range during an active call, the call is automatically placed on hold. Press the
flashing red line button to retrieve a held call when you are back in range of the base station. In
cases when the line button does not light up when you move back into range of the base station,
press the intercom/line button that the call came in on to take the call off hold
NN40110-301 NN40110-301
• Various small businesses
• are typical office facilities with 465 to 929 square
meters (5 000 to 10 000 square feet) of floor space
• have adjacent open space or a yard next to office
•radio transmission is relatively unimpaired in more
open environments because there are fewer path
losses caused by barriers, such as walls
This environment can allow for
base-station-to-handset ranges in excess of 95 m
(300 feet).