Loading The Batteries; Operating Range Of Remote Control - Pioneer VSX-422-K Operating Instructions Manual

1
1
11
Component control buttons
The main buttons (, , etc.) are used to control a component
after you have selected it using the input function buttons.
The controls above these buttons can be accessed after you
have selected the corresponding input function button (BD,
and CD). These buttons also function as described
DVD
below.
Press first to access:
RECEIVER
– Use to adjust Bass or Treble.
BASS +/–, TRE +/–
• These controls are disabled when the listening mode is
set to DIRECT or PURE DIRECT.
• When the front speaker is set at SMALL in the Speaker
Setting (or automatically via the Auto MCACC setup)
and the X.Over is set above 150 Hz, the subwoofer
channel level will be adjusted by pressing
(page 29).
12
Number buttons and other component controls
Use the number buttons to directly select a radio frequency
(page 21) or the tracks on a CD, etc. There are other buttons
that can be accessed after is pressed. (For example
RECEIVER
MIDNIGHT, etc.)
– Press to select ON, AUTO or OFF the surround
SB CH
back channel (page 25).
– Press repeatedly to select a channel, then
CH SELECT
use to adjust the level (page
LEV +/–
– Use to adjust the channel level.
LEV +/–
– Switches to Midnight or Loudness listening
MIDNIGHT
(page 26).
– Use to change the speaker system on or off.
SPEAKERS
When the SP OFF is selected, no sound is output from the
speakers connected to this receiver.
– Dims or brightens the display. The brightness
DIMMER
can be controlled in four steps.
13
SOURCE
Turns on or off the power of the Pioneer DVD/DVR units when
or is selected using the input function buttons.
BD, DVD CD
14
TV CONTROL buttons
These buttons can control only be used with Pioneer TVs.
– Use to turn on/off the power of the TV.

– Use to select the TV input signal.
INPUT
– Use to select channels.
CH +/–
– Use to adjust the volume on your TV.
VOL +/–
15
VOLUME +/–
Use to set the listening volume.
16
MUTE
Mutes/unmutes the sound.
17
DISP
Switches the display of this unit. The listening mode, sound
volume, Pre Out setting or input name can be checked by
selecting an input source.
• The Pre Out setting may or may not be displayed,
depending on the input source you have selected.

Loading the batteries

BASS +/–
The batteries included with the unit are to check initial
operations; they may not last over a long period. We
recommend using alkaline batteries that have a longer life.
29).
CAUTION
• Incorrect use of batteries may result in such hazards as
leakage and bursting. Observe the following precautions:
Never use new and old batteries together.
-
Insert the plus and minus sides of the batteries properly
-
according to the marks in the battery case.
Batteries with the same shape may have different
-
voltages. Do not use different batteries together.
When disposing of used batteries, please comply with
-
governmental regulations or environmental public
instruction's rules that apply in your country or area.
Do not use or store batteries in direct sunlight or other
-
excessively hot place, such as inside a car or near a
heater. This can cause batteries to leak, overheat,
explode or catch fire. It can also reduce the life or
performance of batteries.

Operating range of remote control

The remote control may not work properly if:
• There are obstacles between the remote control and the
receiver's remote sensor.
• Direct sunlight or fluorescent light is shining onto the
remote sensor.
• The receiver is located near a device that is emitting
infrared rays.
• The receiver is operated simultaneously with another
infrared remote control unit.
9
Controls and displays
30°
30°
7 m