Controls And Displays; Front Panel - Pioneer VSX-422-K Operating Instructions Manual

Chapter
1
1

Controls and displays

Front panel

1 2 3
MCACC
SPEAKERS DIMMER DISPLAY
INPUT
SELECTOR
STANDBY/ ON
PHONES
9 10
1
INPUT SELECTOR dial
Selects an input source (page 19).
2
MCACC indicator
Lights when Acoustic Calibration EQ (page
Calibration EQ is automatically set to on after the Auto
MCACC setup (page 17)).
3
Receiver control buttons
– Use to change the speaker system on or off.
SPEAKERS
When the SP OFF is selected, no sound is output from the
speakers connected to this receiver.
– Dims or brightens the display. The brightness
DIMMER
can be controlled in four steps.
– Switches the display of this unit. The listening
DISPLAY
mode, sound volume, Pre Out setting or input name can
be checked by selecting an input source.
• The Pre Out setting may or may not be displayed,
depending on the input source you have selected.
4
Character display
See Display on page 7.
4 5 6 7
HDMI
BAND TUNER EDIT TUNE PRESET ENTER
AUTO SURROUND/ ALC/ ADVANCED SOUND
STREAM DIRECT STANDARD SURR SURROUND STEREO RETRIEVER
MCACC
SETUP MIC
11 12 13
5
Tuner control buttons
– Switches between AM, FM ST (stereo) and FM
BAND
MONO radio bands
24) is on (Acoustic
TUNER EDIT
to memorize and name stations for recall
ENTER
(page 21).
TUNE /
PRESET /
(page 21).
6
Remote sensor
Receives the signals from the remote control (see
range of remote control on page
7
HDMI indicator
Blinks when connecting an HDMI-equipped component;
lights when the component is connected
8
MASTER VOLUME
9
STANDBY/ON
8
VSX-422
AV RECEIVER
14
MASTER
VOLUME
20
(page 21).
– Use with /, PRESET /
TUNE
– Used to find radio frequencies (page 21).
– Use to select preset radio stations
Operating
9).
(page 14).
dial
6
15 16
21 22
10
PHONES jack
Use to connect headphones. When the headphones are
connected, there is no sound output from the speakers. The
listening mode when the sound is heard from the headphone
and
can be selected only from PHONES SURR, STEREO or
STEREO ALC mode.
11
Listening mode buttons
AUTO SURROUND/STREAM DIRECT
Auto surround mode (page
playback (page 24).
– Press for standard decoding
ALC/STANDARD SURR
and to switch between the modes of 2 Pro Logic II, 2
Pro Logic IIx, 2 Pro Logic IIz and NEO:6, and the Auto
level control stereo mode (page
– Switches between the various
ADVANCED SURROUND
surround modes (page 24).
– Press to select stereo playback
STEREO
12
SOUND RETRIEVER
Press to restore CD quality sound to compressed audio
sources (page 24).
17 18 16 19
23 24 25 24 26
– Switches between
23) and Stream Direct
23).
(page 23).