Using the Home Menu
The following section shows you how to make detailed
settings to specify how you're using the receiver, and also
explains how to fine-tune individual speaker system settings
to your liking.
The OSD will not appear if you have connected using the
HDMI output to your TV. Use composite connections for
If headphones are connected to the receiver, disconnect
Switch on the receiver and your TV.
to switch on.
Switch the TV input to the input that connects this
receiver to the TV through the corresponding
, then press
The Home Menu appears on your TV. Use
on the remote control to navigate through the
screens and select menu items. Press
the current menu.
at any time to exit the Home
Select the setting you want to adjust.
Auto MCACC – This is a quick and effective automatic
surround setup (see
sound (MCACC) on page
Manual SP Setup
Speaker Setting – Specify the size and number of
speakers you've connected (see below).
X.Over – Specify which frequencies will be sent to the
Channel Level – Adjust the overall balance of your
Speaker Distance – Specify the distance of your
speakers from the listening position
Input Assign – Specify what you've connected to the
ANALOG IN1 audio input (see
Pre Out Setting – Specify how to use the PRE OUT SURR
BACK/FRONT HEIGHT outputs (see
Auto Power Down – Sets to automatically turn off the
power when the receiver has not operated for several hours
The Auto Power Down menu on page
FL Demo Mode – Sets the demo display on the front panel
The FL Demo Mode menu on page
HDMI Setup – Set the audio return channel function (see
The HDMI Setup menu on page
Ho me Me nu
1. Auto MCACC
2.Manual SP Setup
4.Pre Out Setting
5.Auto Power Down
6.FL Demo Mode
Re tu rn
Automatically setting up for surround
The Input Assign menu on
The Pre Out Setting on
Manual speaker setup
This receiver allows you to make detailed settings to optimize
the surround sound performance. You only need to make
these settings once (unless you change the placement of your
current speaker system or add new speakers).
These settings are designed to fine-tune your system, but if
you're satisfied with the settings made in
setting up for surround sound (MCACC) on page
necessary to make all of these settings.
Depending on the Pre Out Setting, there will be
differences in the speaker items that can be adjusted. The
OSD display for these operating instructions is an example
of when the Pre Out Setting is set to Surr. Back.
Use this setting to specify your speaker configuration (size,
number of speakers). It is a good idea to make sure that the
settings made in
Automatically setting up for surround sound
(MCACC) on page 17
Select 'Manual SP Setup' from the Home Menu.
Select 'Speaker Setting' from the Manual SP Setup
2.Manual SP Setup
Choose the set of speakers that you want to set then
select a speaker size.
to select the size (and number) of each of the
Front – Select LARGE if your front speakers reproduce bass
frequencies effectively, or if you didn't connect a
subwoofer. Select SMALL to send the bass frequencies to
17, it isn't
[ SMALL ]
[ SMALL ]