Loading The Batteries; Operating Range Of Remote Control - Pioneer VSX-521 -K Operating Instructions Manual

Controls and displays
CH SELECT – Press repeatedly to select a channel, then use
LEV +/– to adjust the level (page 31).
LEV +/– – Use to adjust the channel level.
EQ – Press to switch on/off Acoustic Calibration EQ setting
(page 26).
MIDNIGHT – Switches to Midnight or Loudness listening
(page 28).
SPEAKERS – Use to change the speaker system on or off.
When the SP OFF is selected, no sound is output from the
speakers connected to this receiver.
PHASE – Press to switch on/off Phase Control (page 27).
DIMMER – Dims or brightens the display. The brightness can
be controlled in four steps.
12
 SOURCE
Turns on or off the power of the Pioneer DVD/DVR units when BD,
DVD, DVR/BDR or CD is selected using the input function buttons.
13
TV CONTROL buttons
These buttons can control only be used with Pioneer TVs.
 – Use to turn on/off the power of the TV.
INPUT – Use to select the TV input signal.
CH +/– – Use to select channels.
VOL +/– – Use to adjust the volume on your TV.
DTV/TV* – Switches between the DTV and analog TV input
modes for Pioneer TVs.
14
SIGNAL SEL
Press to select the audio input signal of the component to play
back (page 21).
15
MASTER VOLUME +/–
Use to set the listening volume.
16
MUTE
Mutes/unmutes the sound.
17
DISP
Switches the display of this unit. The listening mode, sound
volume, Pre Out setting or input name can be checked by
selecting an input source.
• The Pre Out setting may or may not be displayed, depending
on the input source you have selected.
18
SHIFT
Press to access the 'boxed' commands (above the buttons) on the
remote. These buttons are marked with an asterisk (*) in this
section.

Loading the batteries

The batteries included with the unit are to check initial operations;
they may not last over a long period. We recommend using
alkaline batteries that have a longer life.
CAUTION
• Incorrect use of batteries may result in such hazards as
leakage and bursting. Observe the following precautions:
Never use new and old batteries together.
-
Insert the plus and minus sides of the batteries properly
-
according to the marks in the battery case.
Batteries with the same shape may have different voltages.
-
Do not use different batteries together.
When disposing of used batteries, please comply with
-
governmental regulations or environmental public
instruction's rules that apply in your country or area.
Do not use or store batteries in direct sunlight or other
-
excessively hot place, such as inside a car or near a heater.
This can cause batteries to leak, overheat, explode or catch
fire. It can also reduce the life or performance of batteries.

Operating range of remote control

The remote control may not work properly if:
• There are obstacles between the remote control and the
receiver's remote sensor.
• Direct sunlight or fluorescent light is shining onto the remote
sensor.
• The receiver is located near a device that is emitting infrared
rays.
• The receiver is operated simultaneously with another infrared
remote control unit.
30°
30°
7 m
01
01
9
En