Connecting The Speakers; Connect The Surround Back Or Front Height Speakers - Pioneer VSX-422-K Operating Instructions Manual

2
2

Connecting the speakers

The receiver will work with just two stereo speakers (the front speakers in the diagram) but
using at least three speakers is recommended, and a complete setup is best for surround
sound.
Make sure you connect the speaker on the right to the right (R) terminal and the speaker on the
left to the left (L) terminal. Also make sure the positive and negative (+/–) terminals on the
receiver match those on the speakers.
You can use speakers with a nominal impedance between 6 Ω and 16 Ω.
Be sure to complete all connections before connecting this unit to the AC power source.
Bare wire connections
Front speaker terminals:
1
Twist exposed wire strands together.
2
Loosen terminal and insert exposed wire.
3
Tighten terminal.
Center and surround speaker terminals:
1
Twist exposed wire strands together.
2
Push open the tabs and insert exposed
wire.
3
Release the tabs.
CAUTION
• These speaker terminals carry HAZARDOUS LIVE voltage. To prevent the risk of electric
shock when connecting or disconnecting the speaker cables, disconnect the power cord
before touching any uninsulated parts.
• Make sure that all the bare speaker wire is twisted together and inserted fully into the
speaker terminal. If any of the bare speaker wire touches the back panel it may cause the
power to cut off as a safety measure.

Connect the surround back or front height speakers

Connect the PRE OUT SURR BACK/FRONT HEIGHT outputs of the unit and additional
amplifier to add a surround back or front height speaker.
• The Pre Out setting must be set if the above connections are performed. Select Surr.Back if
the surround back speaker is connected and Height if the front height speaker is connected
(If neither the surround back speaker nor the front height speaker is connected, either
setting will suffice) (see The Pre Out Setting on page
• You can use the additional amplifier on the surround back channel pre-outs for a single
speaker as well. In this case plug the amplifier into the left (L (Single)) terminal only.
1 2 3
10 mm
1 2 3
10 mm
31).
Subwoofer Front right
LINE LEVEL
INPUT
HDMI OUT
IN IN
PREOUT
DVD SAT/CBL GAME
BD
SUBWOOFER
PRE OUT
SUB WOOFER
PRE OUT
PREOUT
SURR BACK/
FRONT HEIGHT
MONITOR SAT/CBL DVD
OUT IN IN
DVD SAT/CBL ANALOG IN
ASSIGNABLE
VIDEO AUDIO
Surround right
Right
R L
ANALOG
AUDIO IN
Surround back or front height
channel amplifier
11
Connecting your equipment
Center
ASSIGNABLE
IN IN
1 1 ASSIGNABLE
( TV ) ( CD )
OPTICAL COAXIAL
SURR BACK/
FRONT HEIGHT
L
( Single )
ANTENNA FRONT
R L
R CENTER SURROUND
AM LOOP
R L
L
IN
R
FM UNBAL
( CD )
1
75
CAUTION: ATTENTION:
FRONT
SPEAKERS A SPEAKER IMPEDANCE ENCEINTE D'IMPEDANCE DE
CENTER
6 -16 . 6 -16 .
R L
Surround left
Surround back or
front height speakers
Left
R L
SPEAKER SPEAKER
Front left
SURROUND
R L