Replacing A Rear Turn Signal Light Bulb; Replacing A License Plate Light Bulb - Yamaha XVS95CTB Owner's Manual

Replacing a rear turn signal
light bulb
1. Remove the turn signal lens by re-
moving the screws.
1. Screw
2. Remove the burnt-out bulb by
pushing it in and turning it counter-
clockwise.
PERIODIC MAINTENANCE AND ADJUSTMENT
EAU42452
1. Turn signal light lens
2. Turn signal light bulb
3. Insert a new bulb into the socket,
push it in, and then turn it clock-
wise until it stops.
4. Install the lens by installing the
screws. NOTICE: Do not over-
tighten the screws, otherwise
the lens may break.
Replacing a license plate light
bulb
2
1
1. Remove the license plate light unit
1. Nut
2. Washer
3. Rubber damper
[ECA10681]
2. Remove the license plate light lens
7-32
by removing the nuts, washers and
rubber dampers.
1 2 3 1 2 3
by removing the nuts and washers.
EAU24324
7