Replacing A Front Turn Signal Light Bulb; Replacing The Tail/Brake Light Bulb Or A Rear Turn Signal Light Bulb - Yamaha MIO AL115S 2010 Owner's Manual

Replacing a front turn signal
light bulb
NOTICE
_
It is advisable to have a Yamaha
dealer perform this job.
_
1. Place the scooter on the center-
stand.
2. Remove cowling A. (See page
7-6.)
3. Remove the socket (together with
the bulb) by turning it counter-
clockwise.
1
ZAUU0261
1. Front turn signal light bulb socket
4. Remove the burnt-out bulb by pull-
ing it out of the socket.
PERIODIC MAINTENANCE AND ADJUSTMENT
5. Insert a new bulb into the socket
EAUU0591
by pushing it in until it stops.
NOTICE
ECA10670
If a turn signal light bulb of different
wattage than
used, the turn signal light flashing
may be affected.
6. Install the socket (together with the
bulb) by turning it clockwise.
7. Install the cowling.
Replacing the tail/brake light
bulb or a rear turn signal light
ECAU0080
bulb
Place the vehicle on the centerstand.
recommended is
Tail/brake light bulb
1. Open the seat. (See page 4-8 for
2. Remove the tail/brake light bulb
ZAUU0154
1. Tail/brake light bulb socket
3. Remove the burnt-out bulb from
7-31
seat opening and closing proce-
dures.)
socket by turning it counterclock-
wise.
the socket by pushing it in and
turning it counterclockwise.
EAUU0302
7