1. Removing the Case Assembly from the
Chassis
1. Remove the volume knob q and selector knob w.
2. Remove the two screws e.
3. Lift and remove the chassis from the case assembly r.
Case assembly
2. Removing the TX-RX unit from the
Chassis
1. Remove the packing t from the chassis.
2. Remove the holder y from the chassis.
3. Detach the solder of speaker wire and mic wire from the
PCB beforehand.
4. Remove the packing u from the SP/MIC jack of the TX-
RX unit.
5. Remove the FPC from the fl at cable connectors i o.
6. Remove the 13 screws !0 fi xing the TX-RX unit.
Note: Take care not to put stress onto the FPC when re-
moving the screw, as the FPC is sitting on the screw.
7. Lift and remove the TX-RX unit from the chassis !1 .
DISASSEMBLY FOR REPAIR
TK-3360
7