Kenwood TK-3360 Service Manual page 6

TK-3360
2. Man-down Tilt Switch
(KCT-57MS: Option for K type)
The KCT-57MS is available only through Kenwood U.S.A.
Corporation.
The Man-down tilt switch can be installed in the trans-
ceiver. This section describes how to install the Man-down
tilt in the TK-2360/3360.
Installing of the KCT-57MS
2-1. Cut lead to approximately 0.12inch (3mm).
0.12inch
3mm
2-2. Solder the cables(black: E37-1102-05 and red:
E37-1101-05) to the position shown in the fi gure.
2-3. Cut the sheet (G10-0795-04)
black red
1/4
KCT-57MS
3/4
0.98inch
(25mm)
2-4. Solder the KCT-57MS to the TX-RX PCB.
Connect the 2 cables from the KCT-57MS to the position
shown in the following fi gure.
6
INSTALLATION
cut
0.12inch
3mm
KCT-57MS
Fig. 1
black red
KCT-57MS
Fig. 2
SHEET (G10-0795-04)
2/4
KCT-57MS
cut
4/4
Fig. 3
FPC
red
Fig. 4
2-5. The double-faced tape is put on the position
of fi gure.
Fig. 5
2-6. KCT-57MS is installed in the holder as shown
in fi gure.
KCT-57MS
Fig. 6
2-7. The holder is installed in the chassis.
KCT-57MS
Fig. 7
G
I
black
Holder
double-faced
tape
black
KCT-57MS
red