Adding Front Brake Fluid; Checking The Front Brake Linings - KTM 125 SX 2010 Owner's Manual

Hide thumbs Also See for 125 SX 2010:

Table of Contents

MAINTENANCE WORK ON CHASSIS AND ENGINE

Adding front brake fluid

Danger of accidents Failure of the brake system.

If the brake fluid level falls below the MIN mark, this indicates a leakage in the brake system or worn-out brake linings.

Check the brake system and do not continue riding. (Your authorized KTM workshop will be glad to help.)

Skin irritation Brake fluid can cause skin irritation on contact.

Avoid contact with skin and eyes, and keep out of the reach of children.

Wear suitable protective clothing and goggles.

If brake fluid gets into your eyes, rinse thoroughly with water and contact a doctor immediately.

Danger of accidents Reduced braking effect caused by old brake fluid.

Change the brake fluid of the front and rear brakes according to the service schedule. (Your authorized KTM workshop will

be glad to help.)

Environmental hazard Hazardous substances cause environmental damage.

Oil, grease, filters, fuel, cleaners, brake fluid, etc., should be disposed of as stipulated in applicable regulations.

Never user DOT 5 brake fluid! This is based on silicone oil and is colored purple. Oil seals and brake lines are not designed for

DOT 5 brake fluid.

Avoid contact between brake fluid and painted parts. Brake fluid attacks paint!

Use only clean brake fluid from a sealed container!

Danger of accidents Reduced braking efficiency caused by worn brake linings.

Change worn brake linings immediately. (Your authorized KTM workshop will be glad to help.)

Move the brake fluid reservoir mounted on the handlebar to a horizontal position.

Remove screws

Remove cover

Add brake fluid to level

top edge of container)

Brake fluid DOT 4 / DOT 5.1 (

Position the cover with the membrane. Mount and tighten the screws.

Clean up overflowed or spilt brake fluid immediately with water.

with membrane

(brake fluid level below

5 mm (0.2 in)

Table of Contents