Noraxon TeleMyo 2400T V2 User Manual page 37

Noraxon U.S.A., Inc.
11
A wireless communication link will be established between the transmitter(s) and the Noraxon Wireless PC
LAN Card. When the measurement is initiated, the status indicator on the transmitter(s) will blink at the
fast speed of 4Hz. Also, the status indicator on the PCMCIA receiver will glow green.
P-2308TV2 Rev G (06-06-11)
6
7
9
10
TeleMyo 2400T V2
6) Click "Test Transmitters"
NOTE: This is the screen you need
to access to set the Gains, Cut Off
Frequency and the RF channel.
"Lock All" sets that gain for all
channels.
7) In the displayed window, you
should see the following if your
transmitter is connected. If you have
7
a 16 channel unit, you will see data
for two transmitters.
8) Click OK for all the dialog boxes
until you are back at the
Measurement Setup screen
9) In the channels box, select the
number of channels that will be used
to acquire the data. You can use the
"Muscle Man" to set the channel
names. If you have one transmitter,
you can select up to 8 channels.
When using two transmitters, up to
16 channels can be selected. For
three transmitters, up to 24 channels
can be used.
10) The sampling frequency can be
set by double clicking in the "Info"
panel/ "Meas Options" tab. The
frequency field can be set to 1500 or
3000 Hz because these are the only
allowed rates for the 2400T.
11) When all the channels have been
selected, turn the switch on the
2400T transmitter(s) to the "1"
position and press the Start button.
36