Controls And Displays; Front Panel; Status Indicator - Noraxon TeleMyo 2400T V2 User Manual

Noraxon U.S.A., Inc.
9) Click OK for all the dialog boxes until you are back at the Measurement Setup screen.
Your TeleMyo 2400T is now set up to work with MyoResearch XP. At any time you can change the
hardware back to the Demo Driver. The Demo Driver is used to practice using the software without having
any equipment connected.

Controls and Displays

TeleMyo 2400T transmitter

1. Status Indicator

The status indicator blinks at four different rates. Recognizing these differences is helpful in knowing
the state of the wireless communication link between the transmitter and PC card.
1Hz (Slowest Blinking Speed) – In this state, the transmitter is searching for a PC radio card to
communicate to. No link to the Wireless LAN PC card has been made at this point.
2Hz – When the PC radio Card recognizes the transmitter, the Status indicator will begin to blink at a
faster rate. At this point, no EMG data is being transferred; however, the wireless link has been
established.
4Hz (Fastest Blinking Speed) – When the "acquire EMG data" command has been sent from the PC
radio Card to the transmitter, the Status indicator will blink at this rate. When this occurs, EMG data
will be moving along the communication link.
P-2308TV2 Rev G (06-06-11)

Front Panel

3
1
2
8) In the displayed window, you
should see the following if your
transmitter is connected. If you have
8
a 16 channel unit, you will see data
for two transmitters.
5
4
TeleMyo 2400T V2
27