KVH Industries TracPhone V11 Installation Manual page 10

4 Prepare the Belowdecks Units
If you plan to mount the CommBox-ACU and
modem to a horizontal surface, without using the
optional case or an equipment rack, follow these
steps to attach the strain-relief bracket and "L"
mounting brackets.
a. Remove the four #6-32 screws and washers
securing the two retaining straps to the sides
of the modem. Do not remove the top screws
securing the straps to the CommBox-ACU.
b. Attach the strain-relief bracket to the
retaining straps and the modem using the
screws and washers you removed in Step a
(see Figure 12).
c. Attach the supplied "L" mounting brackets to
the sides of the modem using four #6-32
screws and washers (see Figure 13).
d. Once you have completed all system wiring,
mount the modem/CommBox-ACU
assembly to the vessel using fasteners
appropriate for the mounting surface.
Horizontal Surface Mount
Figure 12: Attaching the Strain-Relief Bracket
CommBox-ACU
Retaining
Strap (x2)
Tie-Wrap Strain-Relief
Holes (x42) Bracket
Figure 13: Attaching the Mounting Brackets
CommBox-ACU
Modem
#6 Washer (x4)
#6-32 Screw (x4)
Bracket (x2)
Ø.156" (Ø3.96 mm)
Mounting Hole (x4)
Modem
#6-32 Screw (x4)
#6 Washer (x4)
9