Device Settings; Camera; Ptz - LG LRD5160 Series Owner's Manual

NOTE
• The backup function is not supported on the external USB
CD-ROM driver.
• Available external device for backup.
Device
USB HDD Up to 2 TB.
E-SATA HDD Up to 2 TB.
• Use the recommended external USB devices for preventing
malfunction (See page 76).
• For the latest recommended HDD list, please visit
http://www.lgecommercial.com
• An external media has to be formatted on this unit to prevent
malfunction.
• You cannot use the [Estimate size], [Start Backup] and [Erase
Media] options in backup progressing.
• Do not remove the external device while the backup is in
progress, it may cause a malfunction.
• If you format the external media by using a PC with FAT32, the
media may not be used on this unit.
• Check the size of the selected data and free space of the
external device. If the device does not have enough space,
create space on the device or erase the previously stored data.
1. Select the [Estimate Size] icon and press OK.
The size of the selected data and free space is displayed.
2. Select [OK] and press OK to close the window.
• You cannot stop the backup when the backup is in progress.
• The warning message will appear for the conditions listed
below.
- When the start time and end time are the same value.
- When the start time is later than the end time.
- When you set the time for data that does not exist.
-
When the start time and end time setting are wrong.
- A media does not have enough space.
- When the selected USB device is disconnected.
• The disc burning is carried out by a multi session mode.
• You can see the backup progress status on the system control
bar.
• The estimated size of backup data is only the approximate size.
So you must prepare sufficient space on the media to prevent
lack of space.
• At the scheduled recording time, you can check the backup
status on the system control bar.
• While export is in progress or searching the backup data
from the external USB device, the scheduled backup will
not be started. After the export or backup search is finished,
scheduled backup will be restarted.
• When you set the schedule backup, the backup data size is
estimated from the recording settings of the Setup menu. If
the real recorded data size is over the estimated recording
data size, the schedule backup may not be activated.
Capacity

Device settings

Camera

• Ch: Displays the channel number.
• Name : Set the channel name by using alphabetic letter,
numeric digit and symbols up to 21 characters.
• Audio: Select the input audio channel. You can hear from the
selected input audio channel.

PTZ

Settings for the PTZ cameras connected via the data port of the
RS-485 terminal.
• Channel: Selects the desired channel to set the connected PTZ
camera.
• Port: Selects the connected data port of the RS-485 terminal
on the rear panel. The DATA 2 port is used to control the PTZ
camera connected to DVR or to control by using the LKD1000
controller. If you want to use the PTZ camera via DATA 2 port,
you should set the [Remote Controller ID] to [NONE]. If you use
the LKD1000 controller to control the DVR via DATA 2 port, you
should set the [Remote Controller ID] number between 1 and
16.
• Control ID: Selects the PTZ camera ID. Make the same settings
as the PTZ camera.
• Protocol: Selects the protocol supported by PTZ camera.
• Baud Rate: Selects the communication speed.
• PTZ Test: After the PTZ setting, you can test the pan/tilt function
for the selected PTZ camera. You can see the test screen from
the preview windows on the right side of the PTZ test option.
- a/d: Tests the pan direction.
Installation 31
3