Atm/Pos; Storage - LG LRD5160 Series Owner's Manual

32 Installation
- w/s: Tests the tilt direction.
NOTE
The supported PTZ camera list is on page 77 for reference.

ATM/POS

3
• Interface Device: Select the interface device from the drop-
down list.
- NONE: Selects when the ATM/POS device is connected with
the DVR directly.
- AVE Hydra: Selects when the ATM/POS device is connected
via the AVE Hydra device to the DVR. If you set to AVE Hydra,
the [Camera], [Baud Rate], [Data Bits], [Stop Bits] and [Parity]
options are dimmed and these options cannot be set.
• Camera: Select the camera number for mapping with ATM/POS
device.
• Baud Rate: Select the desired parameter to set the
communication speed between DVR and ATM/POS device.
• Data Bits: Select the number of the data bits for RS-485
communication.
• Stop Bits: Select the desired parameter. The stop bit is added to
the last of data, in asynchronous communication.
• Parity: Select the desired parameter. The parity bit is added to
the data, to perform parity check.

Storage

• Overwrite: : Sets whether you use Overwrighting function.
• Full Warning: When the HDD has overflowed a warning message
is displayed.
• Auto Delete: Sets the auto delete date. If you set the auto delete
date, the recorded data will be deleted except the data within
the selected date period of time. The Auto Delete function is
activated every 35 minutes.
• Storage Saving : Saves the storage space by reducing the quality
of the recorded data.
• Format: Initializes the HDD (Hard Disk Drive). All data on the
HDD will be erased.
• E-SATA : Selects the E-SATA device.
• Insert: Uses the selected E-SATA storage for recording data.
• Eject: Uses the selected E-SATA storage for data back-up.