Mount Cable Connections - MotoSAT Nomad 2 Owner's Manual

Connect the Control Cable and the NOMAD "IN" co-axial cable to the Mount
according to the diagram below which corresponds to your Mount.
TWO OUTPUT CONNECTOR:
Executive, MD500, MHDTV, MD1000.2, MSC60
FOUR OUTPUT CONNECTOR:
HD-SL5, HD-SC2
FOUR OUTPUT CONNECTOR:
When using the MotoSAT™ HD-DP3 in Dish Network
*
as an input from an external dish. Do not use this connection to input to the NOMAD,
or to a satellite receiver.
† Any output can be used as an output to the NOMAD, except as noted with the HD
DP-3 above. Default output to the NOMAD is Red.

MOUNT CABLE CONNECTIONS

HD-DP3 DISH NETWORK
9-PIN CONTROL CABLE
OUTPUT TO NOMAD
OUTPUT TO NOMAD
9-PIN CONTROL CABLE
©
DO NOT USE!
OUTPUT TO NOMAD
9-PIN CONTROL CABLE
systems, this connection is used
©
†
†
*see below
†
6