Setting Service And Mount Type - MotoSAT Nomad SD User Manual

SETTING SERVICE AND MOUNT TYPE

To SET SERVICE TYPE after you are in the programming mode.
(Note: Pressing the FIND BUTTON will toggle through SERVICE TYPE.)
• The FIND LED indicates the Network ID (or SERVICE TYPE) selected. It will blink
the number of the current settings, pause, and the repeat the pattern according to the
following table:
SERVICE TYPE
Slow Blink
1= Dish Network
2= DirecTV
3= BELL TV
Rapid
4= Not used
Blink
5= Dish Network EAST
6= Dish Network WEST
7= DirecTV ENHANCED
8= Dish Network HD
** SHAW Direct
*NOTE: A slash (/) between the satellites indicates the system will only see one satellite at a
time. A comma (,) between the satellites indicates the system will see all these satellites at
the same time.
Once eight (8) rapid blinks is reached the process will start back at one (1) if the FIND button is
pressed again.
To SET MOUNT TYPE
(Note: Pressing the STOW button will toggle between Skewable and Non-Skewable
mount configurations.)
• The STOW LED will indicate Skewable or Non-Skewable type mounts
Skewable = ON,
Non-Skewable = OFF.
Please note: In the case of Dish Network EAST, Dish Network WEST and DirecTV
ENHANCED or a Star Choice mount the STOW LED will automatically be set according to the
type of mount used for that particular type of configuration.
SAVING SETTINGS
• To save the current configuration setting, turn off the unit and turn it back on again
normally and that will store your settings. At this time please perform a TEST DISH to
match the Controller to the Mount. After a successful Test Dish...
PRESS THE "FIND" BUTTON TO ACQUIRE YOUR PROGRAMMED SATELLITES.
MOUNT TYPES
NON SKEWABLE *
119/110
101
91/82
61.5/110/119
110/119/148
101/119
110/119/129
** LOAD SHAW Direct Software Revision
HIGHER and the CONFIGURATION IS AUTOMATIC
12
SKEWABLE *
110,119
99,101,103,110,119
82,91
N/A
N/A
N/A
110,119,129
107.3,111.1
nsd_1000.hex OR
.