Operating The Nomad - MotoSAT Nomad 2 Owner's Manual

TO FIND A SATELLITE:
1. Turn on the power by pressing the POWER button.
2. Wait for approximately 5 seconds for the NOMAD to complete
its power up sequence.
3. Press the FIND button and the dish will search out and lock
onto the properly programmed satellite(s).
NOTE: Pressing the FIND button after you have locked onto a satellite will
control one of two functions, depending on your system type:
- Non-Skewable Mount: Pressing the FIND button while on satellite enables
you to toggle between multiple satellites. Pressing the FIND button while
locked onto a satellite will direct the system to go to the next satellite in
order such as:
• DIRECTV can toggle between 1010 and 1190.
©
• Dish Network
• Dish Network
61.50, 1100, and 1190.
• Dish Network
1100, 1190 and 1480.
• Bell ExpressVu
- Skewable Mount: Pressing the FIND Button will locate all satellites
available with your LNB configuration simultaneously, and re-peak the
dish for higher signal quality. For Programming Options and their assigned
satellites, see "NOMAD Programming Options" on page 11.
TO STOW THE DISH:
1. Press the STOW button and the dish will stow, returning to the
proper travel position.
POWER BUTTON

OPERATING THE NOMAD

can toggle between satellites 1100, 1190 and 1290.
©
International East can toggle between satellites
©
International West can toggle between satellites
©
© can toggle between satellites 820 and 910.
FIND BUTTON STOW BUTTON
18