3
3.4.5
Plug in and power up
1
Plug the non-pronged end of the
supplied AC power cord into the AC
socket on the machine and the
pronged end into a properly ground-
ed AC outlet.
7IMPORTANT
Be sure that you do not turn the power on until after you have unlocked
%
the scanner unit locking switch. (See page 3-8.)
2
Turn on the power switch. The markings are international standards:
[I] means on, [O] means off.
It will take a few seconds for the machine to warm up. The machine
shows:
Then the machine shows:
To use the machine, turn off the
transport mode.
Note
During the power is on, the scanner lamp will always light, but this is not
machine failure, it is need to prolong the life of your machine's scanner
lamp.
3-14
Layout and installation
bizhub 131f/190f