To Review Or Cancel The Commands - Konica Minolta bizhub 131f Advanced Information

Sending Faxes
9.4.1

To review or cancel the commands

1
Press [Job Confirm].
If your machine is attempting to
-
perform a command now, the
machine shows it.
If you want to cancel the com-
-
mand, go to step 3.
2
Press [Enter].
The machine shows the first command, indicated by its command
number and the phone number it will dial.
Here, you see Command No.: 01, and the number it is set to dial. If the
command is to send a broadcast (see page 9-23), "Broadcast" ap-
pears instead of the phone number.
If the command is to send a batch transmission (see page 9-27), the
machine shows its batch box number (such as "B01" rather than the
command number).
If the command is for a Call group dialing (see page 8-16), the group
number (such as "G01") appears instead of the phone number.
If the command is for a polling (see page 10-17), the machine shows
polling number (such as "P01") rather than the command number.
If there are no stored commands in your machine, the machine shows
"No Command Stored". Press [Reset] to return to standby mode.
3
Press [,] or [+] to scroll through currently stored commands.
4
If you want to cancel the command shown, press [Cancel].
The following two displays will appear alternately:
bizhub 131f/190f
9
9-15