Kodak Ngenuity 9000 Series Maintenance Manual page 6

A-61719 September 2010
Always remove the rollers from the scanner for cleaning to ensure best
results.
1. Turn off the scanner and unplug it from the wall outlet.
1. Open the transport cover.
2. Remove the pick roller by rotating the pick roller release lever up,
push the pick roller to the right and rotate it out of position.
3. Using a roller cleaning pad, scrub the roller tires in a side-to-side
motion. Rotate the roller to clean the entire surface.
IMPORTANT: The roller cleaning pad contains sodium lauryl ether
sulfate and sodium silicate which can cause eye
irritation. Wash hands after use. Refer to the MSDS
for more information.
4. Re-install the clean pick roller.
• With the pick roller positioned so the dots are facing the left side,
slide the roller onto the right pick roller shaft.
• Holding onto the roller, rotate the pick roller shaft down and slide
the roller all the way to the left. The right side of the roller should
be clear of the pick roller release lever.
• Rotate the pick roller release lever down and snap it into place.
5