Kodak Ngenuity 9000 Series Maintenance Manual page 11

10
Cleaning the sensors
There are 7 sensors that require regular cleaning. Use only the
supplied blower brush to clean these sensors. Do not use any type of
cotton swab or cloth as these items may leave lint in the sensors.
9. Feeder sensor: Place the brush end of the blower brush into the
feeder sensor area and squeeze the blower brush several times to
clean the feeder sensor on the feeder table.
10. Gap sensor, page entry sensors and pass thru sensor: Open
the transport cover to clean these 5 sensors by placing the brush
end of the blower brush into the each sensor area and squeeze the
blower brush several times to clean.
Top or front page tray assembly
Feeder sensor
Gap sensor
Page entry
sensors (3)
Pass thru
sensor
A-61719 September 2010