Cleaning Procedures - Kodak Ngenuity 9000 Series Maintenance Manual

Cleaning procedures

A-61719 September 2010
Cleaning your scanner and performing preventative maintenance on a
regular basis is required to ensure the best possible image quality.
Some document types generate more paper dust and debris and may
require more frequent cleaning.
Before cleaning your scanner or replacing consumables, review the
following information:
• Turn the scanner off and unplug it from the wall outlet before
performing maintenance procedures.
• Remove any jewelry or any items from hands or wrists that could
become caught on internal scanner components.
• Some debris from the rubber tires on the skimmer module and
separator roller is normal. Tire debris does not always mean that the
tires are worn or damaged. After cleaning, inspect the tires for wear
and replace the separator roller or skimmer module if necessary.
• When cleaning rollers/tires, allow the rollers/tires to dry completely
before scanning.
• Use only the recommended cleaning supplies. Using unapproved
cleaning fluids or solvents may damage the rubber tires.
• Do not use cleaners in confined areas; use with adequate
ventilation.
• Do not use flammable compressed aerosols on or around the
scanner.
NOTE: To access the Material Safety Data Sheet (MSDS), you will
need to provide the catalog number or keyword of the
supply. See "Supplies and Consumables" later in this
chapter for catalog numbers.
3