Introduction; Installation Of Ethernet Driver; Installation For Ms-Dos And Windows 3.1 - Advantech PCA-6753F User Manual

Half-size all-in-one gxm sbc with cpu, vga/lcd and ethernet

Table of Contents

6.1

Introduction

The PCA-6753F is equipped with a high performance 32-bit

Ethernet chipset which is fully compliant with IEEE 802.3 100

Mbps CSMA/CD standards. It is supported by major network

operating systems. It is also both 100Base-T and 10Base-T

compatible. The medium type can be configured via the

RSET8139.exe program included on the utility disk.

The Ethernet port provides a standard RJ-45 jack on board. The

network boot feature can be utilized by incorporating the boot

ROM image files for the appropriate network operating system.

The boot ROM BIOS files are combined with system BIOS, which

can be enabled/disabled in the BIOS setup.

6.2

Before installing the Ethernet driver, note the procedures below.

You must know which operating system you are using in your

PCA-6753F, and then refer to the corresponding installation flow

chart. Then just follow the steps described in the flow chart. You

will quickly and successfully complete the installation, even if you

are not familiar with instructions for MS-DOS or Windows.

Note:

If you want to set up your Ethernet connection under the MS-DOS

or Windows 3.1 environment, you should first check your server

system model. For example, MS-NT, IBM-LAN server, and so on.

Then choose the correct driver to install in your panel PC.

The installation procedures for various servers can be found on

CD-ROM; the correct path being "D:\6753\Ethernet.100\wfw311".

PCA-6753F User's Manual

The windows illustrations in this chapter are

examples only. You must follow the flow chart

instructions and pay attention to the instructions

which then appear on your screen.

Table of Contents